RG-26E
General-purpose plastic granulator
Cut sprues, runners and production offcuts into regrind for a planned recovery process.
View details for RG-26E General-purpose plastic granulatorRG-27R
Slow-speed processing of small sprues and rejects using toothed cutting elements without a sizing screen.
The RG-27R is a slow-speed, screenless granulator for small sprues and molding rejects beside an injection machine. Toothed cutting elements break the material down without a screen beneath the rotor. This construction makes the incoming sprue geometry and the cutting configuration important when reviewing the required regrind.
The catalogue describes manual or robot feeding and names RG-2730R, RG-2740R and RG-2750R variants. Each variant needs its own specification; a shared series name does not make their chamber dimensions or motor ratings identical.
A low-speed granulator with a sizing screen is a different cutting arrangement. Compare the screenless and screened routes by runner geometry, feeding conditions and the required regrind in the selection guide.
The published catalogue instructs that scrap should be at normal temperature before cutting, to avoid hot material sticking to the blades. Include the molding cycle and the time between ejection and feeding when discussing an immediate recycling layout.
For clear or colour-sensitive products, describe the resin, contamination controls and acceptable regrind. A screenless construction alone cannot establish that recovered material meets the finished product's quality requirements.
The chamber opens for cleaning and the catalogue shows blower and proportional-valve return arrangements. Plan the collection route and access between material changes. Send sprue photographs, maximum section thickness and the intended return destination. The central granulator range provides a different handling route for collected batches of scrap.
A screenless granulator and a screened granulator can both recover injection molding sprues beside the press. Compare the cutting arrangement against the runner shape, the way it …
Use the same material, output requirement and operating conditions when comparing machines. Start with the scrap that will actually reach the feed opening.
Send your requirements or questions to RHONG.